RCytoscape (version 1.22.0)

setNodeOpacityRule: setNodeOpacityRule

Description

Specify how data attributes -- for the specified named attribute -- are mapped to node opacity. There are two modes: 'interpolate' and 'lookup'. In the former, you specify data values ('control points') and opacitys; when a node's corresponding data attribute value is exactly that of a control point, the specified opacity is used. If the node's data attribute falls between control points, then the opacity is interpolated.

The 'lookup' mode provides no interpoloation, and is useful when you have a node attribute with a finite set of discrete values, each of which you you want to display in a specific opacity. For example: render all receptors with full brightness, all transcription factors faded by 50

Usage

setNodeOpacityRule(obj, node.attribute.name, control.points, opacities, mode, aspect='all')

Arguments

obj

a CytoscapeWindowClass object.

node.attribute.name

the node attribute whose values will, when this rule is applied, determine the opacity of each node.

control.points

a list of values. In interpolate mode, a typical choice is the minimum, the maximum, some sensible midpoint.

opacities

a list of opacities, either two more than the number of control points (if mode='interpolate'), in which case the first opacity is used for all attributes values below the minimum, and the last opacity is used for those above the maximum. Or, if mode='lookup', the same number of opacities as control.points are expected. Opacities are expressed as integers in the range 0:255, from invisible to fully bright rendering.

mode

'interpolate' or 'lookup'. This roughly corresponds to the visual mapping of continuously varying data (i.e., lfc or pValue), versus visual mapping of discrete data (i.e., molecule type, or phosphorylation status). With the interpolation mode, you must specify n+2 opacitys: adding a 'below' and an 'above' opacity. In lookup mode, specify exactly as many control.points as opacitys. If are data attribute values are found on the nodes which do not appear in your list, they will displayed in the default opacity.

aspect

a character string, with one or more of these values: 'border', 'label', 'fill', 'all'

Value

None.

See Also

setNodeColorRule, setNodeOpacityDirect

Examples

  cw <- new.CytoscapeWindow ('setNodeOpacityRule.test', graph=makeSimpleGraph())
  displayGraph (cw)
  control.points <- c (-3.0, 0.0, 3.0)   # typical range of log-fold-change ratio values
  opacities <- c (128, 80, 255)  
  setNodeOpacityRule (cw, node.attribute.name='lfc', control.points, opacities, mode='interpolate', aspect='all')
  redraw (cw)
    # now restore full opacities
  gene.types <- c ("kinase", "transcription factor", "glycoprotein")
  setNodeOpacityRule (cw, 'type', gene.types, c (255, 255, 255),  mode='lookup', aspect='all');
  redraw (cw)
    # leaving node labels fully opaque -- fully visible -- change border   and fill opacity
  opacities <- c (10, 80, 255)
  setNodeOpacityRule (cw, node.attribute.name='type', gene.types, opacities, mode='lookup', aspect='border,fill')
  redraw (cw)