Creates a Kinesis data stream. A stream captures and transports data records that are continuously emitted from different data sources or producers. Scale-out within a stream is explicitly supported by means of shards, which are uniquely identified groups of data records in a stream.
You specify and control the number of shards that a stream is composed of. Each shard can support reads up to five transactions per second, up to a maximum data read total of 2 MiB per second. Each shard can support writes up to 1,000 records per second, up to a maximum data write total of 1 MiB per second. If the amount of data input increases or decreases, you can add or remove shards.
The stream name identifies the stream. The name is scoped to the AWS account used by the application. It is also scoped by AWS Region. That is, two streams in two different accounts can have the same name, and two streams in the same account, but in two different Regions, can have the same name.
create_stream is an asynchronous operation.
Upon receiving a create_stream request,
Kinesis Data Streams immediately returns and sets the stream status to
CREATING. After the stream is created, Kinesis Data Streams sets the
stream status to ACTIVE. You should perform read and write operations
only on an ACTIVE stream.
You receive a LimitExceededException when making a
create_stream request when you try to do one
of the following:
Have more than five streams in the CREATING state at any point in
time.
Create more shards than are authorized for your account.
For the default shard limit for an AWS account, see Amazon Kinesis Data Streams Limits in the Amazon Kinesis Data Streams Developer Guide. To increase this limit, contact AWS Support.
You can use describe_stream to check the
stream status, which is returned in StreamStatus.
create_stream has a limit of five
transactions per second per account.
kinesis_create_stream(StreamName, ShardCount)[required] A name to identify the stream. The stream name is scoped to the AWS account used by the application that creates the stream. It is also scoped by AWS Region. That is, two streams in two different AWS accounts can have the same name. Two streams in the same AWS account but in two different Regions can also have the same name.
[required] The number of shards that the stream will use. The throughput of the stream is a function of the number of shards; more shards are required for greater provisioned throughput.
An empty list.
svc$create_stream( StreamName = "string", ShardCount = 123 )