reverseR: Linear Regression Stability to Significance Reversal (R-package)
Overview
In biomedical literature, the most widely employed statistical procedure to analyze and visualize the association between two variables is linear regression. Data points that exert influence on the fit and its parameters are routinely, but not as often as required, identified by established influence measures and their corresponding cut-off values. In this R package, we specifically address the presence of influential data points that directly impact the statistical inference of the models, which none of the established measures detect, such as
leverage
dffits
dfbeta(s)
covratio
Cook's distance
studentized residuals
Hadi's measure
We call these data points "reversers". reverseR tests linear regressions for significance reversal through leave-one(multiple)-out and checking if $\alpha \in [p_{\beta1}, p_{\beta1(i)}]$, where $p_{\beta1}$ is the p-value of the regression's slope and $p_{\beta1(i)}$ is the p-value with the i-th point deleted. This paradigm is along the lines of the living-in-oblivion measure dfstat or dfstud (Belsley, Kuh & Welsch, Regression diagnostics: Identifying influential data and sources of collinearity, 2004) that checks the impact of each response value on statistical inference.
Repo Contents
Hardware Requirements
The reverseR package requires only a standard computer with enough RAM to support the operations defined by a user. For minimal performance, this will be a computer with about 4 GB of RAM. For optimal performance, we recommend a computer with the following specs: RAM: 16+ GB; CPU: 4+ Cores, 3.3+ GHz/Core.
Software Requirements
R version greater than 3.5.0 for Linux Ubuntu 16, Windows 7, 8, 10 or Mac.
Several CRAN packages may be needed.
Runtimes
Runtimes vary for the different functions:
lmInfl for "reverser" analysis: ~ 1-5 sec.
lmMult for multiple leave-out analysis: ~ 5-30 sec.
simInfl for Monte Carlo simulation: 5-600 sec.
Package dependencies
Users should install the following packages prior to installing reverseR, from an R terminal:
install.packages(c("markdown", "knitr"))Installation Guide
From an R session, type:
if (!'devtools' %in% installed.packages()) install.packages(devtools)
devtools::install_github("anspiess/reverseR")
source("https://install-github.me/anspiess/reverseR")